Cloud CX335 Specifications Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
CX335 Technical Manual Page 5
have a definite maximum output level that will never be exceeded (many LEDS lit on the
Gain Reduction meter). The Peak Limit LED should never flicker if it is set correctly and
providing that the Gain control is not adjusted too high.
1.04 Soft Knee, Slow Time Constants
This mode of operation will still yield musical results, but will tend to allow the very quick
dynamics through unprocessed. Therefore you will require more peak limiting and a high
overhead in speaker power handling.
Depress the Slow switch. Set the Threshold to somewhere between 10dB and 15dB
LOWER than your average input level and set the Ratio control somewhere between 5:1
and 10:1, if you require compression of the audio signal, but 20:1 or higher if you require
compression and limiting.
With normal programme level running through the CX335, rotate the Gain control so that
the output level on the Left and Right channel VU meters measures about the same in
Bypass mode as it does with the Compressor operational.
Rotate the Peak Limiter control to a position where the peak LED flashes quite often to
capture very high level peaks for speaker protection. The Peak Level is best adjusted by
monitoring or observing the amplifier peak or clip indicator with full level programme
passing through the unit.
With this configuration, the louder the input then the more compression will take place. A
perceived increase in average overall volume should be noted, although the peak output
level should be slightly lower. Some dynamics might cause other problems further down
the signal path.
1.05 Hard knee, Slow time constants
This mode of operation will be the most noticeable (especially with high Ratio settings
and fast dance tracks) as the point where compression takes effect is at a definite audio
level.
SLOW
HARD THRESHOLD
RATIO
PEAK
GAIN
BYPASS
RELEASE
KNEE
0dB
5
+10
-10
-15
-20
3
5
10
20
1.2
1.5
8
2
10
15
20
26
-6
-4
-2
0
3
6
12 12
8
44
8
dB
0
ROTATE TO DESIRED
LIMIT LEVEL
MAKE EQUAL TO
BYPASS LEVEL
SET TO CAPTURE VERY HIGH
PEAK TRANSIENTS
LIMITING
ABOVE 20:1
SLOW
HARD
THRESHOLD
RATIO
PEAK
GAIN
BYPASS
RELEASE
KNEE
0dB
5
+10
-10
-15
-20
3
5
10
20
1.2
1.5
8
2
10
15
20
26
-6
-4
-2
0
3
6
12 12
8
44
8
dB
0
ROTATE UNTIL -15 TO -10dB
BELOW SIGNAL INPUT
MAKE EQUAL TO
BYPASS LEVEL
ROTATE UNTIL LED FLASHES
AT DESIRED OUTPUT
LIMITING
COMPRESSING
SWITCH
DEPRESSED
BELOW 10:1 ABOVE 20:1
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Comments to this Manuals

No comments