Cloud LM-2 Series User's Guide download pdf (Page 18)

Z4-8MK3 Installation and User Guide18

OPTIONS AND ADDITIONAL INFORMATION

LM-2 active input modules – general considerations

Cloud LM-2 remote input modules are available in three form factors, to t double-gang UK, American or German DIN-

standard electrical back boxes. Back boxes of either the recessed type or surface-mounting type may be used, providing they

are at least 35 mm deep.

The modules should be connected to the FACILITY PORT of the relevant zone using screened Cat 5 cable as described at page

12 . The OUTPUT connector on the module and the FACILITY PORT on the mixer are both screened RJ45 connectors.

Great care must be taken when connecting active input modules; power is derived from the mixer and some wiring errors may

cause failure of the mixer. Please check all wiring before testing the system.

IMPORTANT: Please refer to page 24 for information regarding current draw and power supply capability.

Connecting multiple LM-2s

It may be desirable to connect local microphones or music sources at more than one location in a zone (in a large function

room, for example). LM-2 input modules may be “daisy-chained” using their second ‘LINK’ RJ45 connectors to achieve this. All

LM-2s thus wired will, of course, only be available to the zone to whose Facility Port the chain is connected.

Remember to consider the current drawn by any additional input modules – see page 24 for details of current consumption

and PSU capability.

See also the section below: “Disabling the Facility Input Noise Gate”.

Using the Facility Ports as auxiliary zone inputs

The Facility Port provides a balanced audio input. If a port is not connected to an LM-2 remote input module, it may be used

as a direct input to the zone from other equipment forming part of the system (for example, a permanently installed DJ mixer

which only ever needs to feed its output to that particular zone.)

Wire an external balanced source to the facility port as shown below:

Z4MK3/Z8MK3 FACILITY

PORT (RJ45)

BALANCED

OUTPUT (e.g. XLR)

hot (+)

cold (-)

An unbalanced source may also be connected; the use of balancing transformers is recommended.

Disabling the Facility Port Noise Gate

The balanced audio input at the Facility Port is fed through an internal noise gate, to minimise any background noise from

an LM-2 or other source connected to the port. The threshold of the noise gate is xed at a fairly low level, so that use of a

microphone connected to an LM-2 will normally open the gate immediately.

If any problems are experienced with the gate’s operation, it may be disabled by moving jumper J7 on the zone sub-board. When

disabled, even very low-level audio signals from the LM-2 or other external source will be audible.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

Cloud LM-2 Series User's Guide Page 18