Cloud CX335 Specifications Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
CX335 Technical Manual Page 9
COMPRESSORS and LIMITERS
4.01 What is a compressor / limiter?
Compression is an audio process that reduces the output progressively once the input
level has risen above a pre-settable threshold. Once this threshold level is exceeded then
the rate at which the output is reduced is controlled by a predictable rate, called 'ratio'.
Limiting is an extension of compression where once the threshold is exceeded, the output
level will not rise any further. Therefore limiting can also be perceived as a compressor
with its 'ratio' set higher than 20 to 1.
4.02 Threshold explained
As a rotary control, the threshold parameter is easy to understand. Threshold compares
the input level to the level set on the front panel. It is very common to see the graticule
around the threshold control marked from higher levels on the counter clockwise end to
lower input levels on the clockwise end. This is because more compression happens as
the control is turned 'up'.
4.03 What is Hard-knee and Soft-knee?
The actual threshold point where compression takes place is called the 'knee', the reason
being that if a graphical representation of input level verses output level is made, then
below threshold the line will be at 45° (output is the same as input). Above threshold this
line will have a gentler slope equal to the ratio setting. So the line will have a definite 'fold'
or 'knee'. (see following diagram).
With high ratio settings this knee can be very noticeable. To prevent this sudden change
between no compression below threshold and lots of compression above threshold, it is
much gentler on the ear if this knee is 'rounded' or softened. Soft-knee is more musical
and desirable if the actual compression process is not to be too obtrusive. So by default,
the CX335 compressor limiter is a 'soft-knee' device, yet still can be overridden by use of
the Hard switch.
TRANSFORMER
FIT ONE
LINK FOR
220/240
VOLTS
OPERATION
FIT TWO
LINKS FOR
110/120
VOLTS
OPERATION
240V
TRANSFORMER
120V
120V
VIEW INSIDE CX335 SHOWING POSITION OF VOLTAGE SELECTION LINKS
HIGH VOLTAGE
HIGH VOLTAGE
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comments to this Manuals

No comments