Cloud CXM User's Guide download pdf (Page 11)

CXM Technical

MANUAL

3.16 PCB Jumpers

The locations of the PCB configuration jumpers can be seen on the

diagram to the left. The list below explains each jumper, its

approximate position and default settings.

Equalisation jumper, located next to the insert jack socket, factory

set in the active position. 2 possible settings; EQ active or

defeated. No output will be possible from this channel if this jumper

header is missing.

Auxiliary Send 1 Pre / Post Fade, located behind the Aux 1

potentiometer, factory set to Pre Fade. 2 possible settings, Pre or

Post Fade level. Aux Send 1 will not function if this jumper header

is missing.

Auxiliary Send 2 Pre / Post Fade, located behind the Aux 2

potentiometer, factory set to Post Fade. 2 possible settings, Pre or

Post Fade level. Aux Send 2 will not function if this jumper header

is missing.

Phantom Power jumper, located above the 34 way buss connector,

factory set to the Off position. If this jumper header is missing then

+48 Volts phantom power will be Off.

Booth Mute/AutoMute jumper, located to the side of the 34 way

buss connector, factory set to the Off position. If this jumper header

is missing then Booth Mute will never function on this channel.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

No comments

Cloud CXM User's Guide Page 11