Cloud CXM User's Guide download pdf (Page 18)

CXM Technical

MANUAL

CZ1 Zone Module

5.01 The CZ1 Module extends the output facilities of the M1 or M2 Master module by providing

an extra 3 output zones with independent control of microphone and music levels.

5.02 Zone 1

Two faders are provided to independently control the output level of the microphone and

music signals. An internal jumper can be configured to derive the signals either pre

master fader or post master fader and a second jumper is used to set the output to

operate in mono or stereo. Two 3 pin XLR type connectors are used for the balanced

output, rated at OdBu (775mV).

The output can be monitored by selecting the respective PFL select button.

5.03 Zone 2

This operates identically to Zone 1 with addition of auxiliary outputs on a pair of RCA type

phono connectors.

5.04 Zone 3

Again, 2 faders are provided with signals derived post master fader. The automute facility

can be used to mute the output of Zone 3 when any microphone mute switch is in the

"on" position. To enable the "automute" facility, one or more of the CM1 microphone input

modules must be configured to trigger the mute circuit (see 3.16) and the automute

switch should be in the on position.

Zone 3 can also be configured to operate in mono or stereo and provides balanced

outputs via 3 pin XLR type connectors with auxiliary outputs via RCA type phono sockets.

5.05 Fitting the CZ1 to the mixer main frame

The CZ1 zone module connects to the 34 way ribbon cable assembly in much the same

way as other modules. However the CZ1 must be connected to the master module by an

additional 16 way ribbon cable assembly and to facilitate this the CZ1, must be positioned

immediately to the left of the master module.

Proceed as follows:-

Remove the master module and detach the 34 way ribbon cable.

Fit the 16 way ribbon cable to the socket on the M1 PCB and route the cable by the side

of the crossfade control on the edge of the PCB.

Connect the other end of the 16 way cable to the CZ1 module and install the 2 units

together into the main frame.

Make sure that the 34 way main ribbon cable is firmly connected to the CZ1 and master

module(2 sockets)

1 2 ... 13 14 15 16 17 18 19 20 21 22

No comments

Cloud CXM User's Guide Page 18